Helen Frankenthaler Foundation

Oxidative stress inhibitor peptide

Efficacy and Tolerance Study of an Oligopeptide with Potential Anti-Aging Activity

Introduction

Peptides as cosmeceutical ingredients, evolved from research into wound healing and studies on growth stimulation of human skin fibroblasts [1,2]. In recent years there has been increased interest in the use of that signal peptides in the management of aging [3-5]. Palmitoyl pentapeptide-4 (Pal KTTKS) is a procollagen pentapeptide fragment [6] which stimulates collagen I and III and fibronectin production by fibroblasts in vitro and has been shown to decrease skin roughness and wrinkles and fine lines [7] after 4 month application. Copper tripeptide-1 is thought to improve skin firmness and texture, fine lines and hyperpigmentation [8]. Oligopeptide-20 is another synthetic peptide consisted of the following 12 amino acids: Arg-Arg-Leu-Glu-Met-Tyr-Cys-Ala-ProLeu-Lys-Pro [9]. It acts as positive regulator of cell proliferation and increases collagen and hyaluronic acid levels in keratinocyte and fibroblast cultures. In vitro decreases apoptosis rates and increases cell attachmentwhich is a significant part of wound healing and skin regeneration [10]. To the best of our knowledge, there is no study in the bibliography regarding the clinical efficacy of cosmetic products containing oligopeptide-20. As a part of our research program on anti-aging and cosmeceutical agents [11-15], we thought it would be of interest to examine by means of a randomized, vehicle controlled, double blind study the anti-aging properties of a cream containing 0.003% w/w (300 ppm) of the newly synthesized oligopeptide-20. We have used five different assessment methods to examine the effect of topical oligopeptide-20 treatment on the skin: Four noninvasive, bioengineering, objective techniques proposed by EEMCO Group (European Group in Efficacy Measurement of Cosmetics and Other Topical Products) and subjective self-evaluation. Skin surface morphology was examined by a direct non-invasive method with the instrument Skin VisioscanVC98 [16]. Skin microtopography was examined by optical profilometry (negative replica method), which is a useful non-invasive method in trials estimating the effectiveness of anti-wrinkle preparations [17-22]. Pigmentation was examined by the melanin index measurement (Mexameter) [23,24]. The effect of the peptide on skin barrier was also investigated. Transepidermal water loss (TEWL) measurement can screen ingredients that have effect on barrier function and offer the possibility to monitor in vivo on human skin the effect of topical treatment in an objective and noninvasive way [25,26]. Additionally, assessment of skin tolerance of the oligopeptide-20 cream was performed [27,28].

Materials and Methods

Treatment Creams

Creams contained identical vehicle. The active cream contained oligopeptide-20 0.003% w/w (300 ppm). Oligopeptide-20 was donated by Cellco Chemicals Ltd (Athens, Greece), distributor in Greece of Caregen Co., Ltd (South Korea).

Ingredients: Aqua, C12-20 Acid PEG Ester, Glyceryl Stearate (and) PEG-100 Stearate, Cetyl Alcohol, Dimethicone, Octyl Palmitate, Xanthan Gum, Propylene Glycol, Propylparaben, Methylparaben, Imidazolidinyl Urea, BHT.

Equipment

Skin surface evaluation: Skin Visioscan VC98 (Courage and Khazaka, Cologne, Germany). Skin profilometry: Skin Visiometer SV600FW, Melanin content: Mexameter MX18 (MPA5, Courage and Khazaka, Cologne, Germany). Transepidermal water loss: Tewameter TM300 (Courage and Khazaka, Cologne, Germany).

Efficacy Study
Volunteers

Twenty females and two males (age 35 - 75, mean age 55 years) were included in this study. They were selected according to following inclusion criteria:

Discontinuation of treatments by products containing retinoids, a-hydroxyacids and other anti-aging treatments at least six months before the beginning of the study.

Signed Informed Consent

Avoidance of medication such as steroid hormone replacement, birth control pills and vitamin supplements during the study period. At the baseline visit, the participants were instructed not to apply or take orally any other anti-wrinkle products/food supplements and not to apply at each visit, any product on the previous 12 hours.

Study Procedure

The procedure was done according to good clinical practice (GCP) guidelines. Volunteers were visited at the baseline (D0) and D20, D40 and D60.

Skin surface evaluation, skin microtopography, melanin content, transepidermal water loss and were measured before (D0), during (D20, D40) and after the treatment (D60) and self-evaluation was performed by the test subject before (D0) and after 2-month treatment (D60). Side effects were also evaluated by the volunteers.

Two coded 50 g vessels, marked right and left, respectively for use twice daily on each half of the face were distributed at the first visit. At each control used vessels were collected in order to allow calculation of the amount of cream used. Tests were carried out in a halfface, double manner. The participants rested for a 20-min acclimatizing period before the measurements at a room temperature ranging between 19˚C - 21˚C and RH between 40% and 60%. The subject was seated in a comfortable armchair with closed eyes in order to relax. In this position measurements were done on the periocular skin surface.

Skin Surface Evaluation

The surface of living skin was analyzed by the direct non-invasive method using the instrument Skin Visioscan VC98 [16]. In Skin Visioscan technique the image of the skin is taken by a built in CCD-camera. The Surface Evaluation Living Skin (SELS) parameters Sew (wrinkles parameter), calculated from the average number and width of horizontal and vertical wrinkles and Sesc (scaliness parameter), representative of the dryness of stratum corneum, were evaluated [16]. The ideal moisturizing or anti-aging treatment should decrease Sew and Sesc.

Skin Microtopography

Skin Visiometer SV600FW (optical profilometry) is used for non-direct measurement of skin topography [17-22]. To obtain negative imprints of the examined skin area, fast hardened blue silicon and adhesive disks were used. The adhesive disk was layered onto the volunteer’s skin to delimit the investigated area, avoiding skin stretching during the application and keeping track of the specimen orientation. A small amount of silicone was then spread into the internal circular area delimited by the adhesive disk and left in situ for 15 minutes until dry. The disc was next removed obtaining a careful duplicate of the skin surface on the silicone.

The silicon replica was put on a special frame and inserted in the special device where a light source sending out parallel light and a video sensor CCD on the other side. The replica reproduces the skin as a negative i.e. wrinkles are reproduced as mountains as the silicone is thicker in that place. Cyclic average roughness parameter (cR 3) was examined. cR 3 is the average roughness calculated by circular arrangement of the lines in order to compensate the influence from the direction of the wrinkles [19]. The ideal moisturizing or anti-aging treatment should decrease cR 3.

Melanin Measurement

Mexameter MX18 was used to estimate the activity of the oligopeptide on skin pigmentation [23,24].

Self-Assessment

Subjects were asked to provide an assessment of improvement or not at the end of the treatment relative to baseline for fine lines, skin brightness and skin smoothness. These variables were scored on a scale of 1-4 indicating total (4), great (3), moderate (2), slight (1) and none (0).

Transepidermal Water Loss (TEWL)

TEWL measurements [25,26] were included to determine if the oligopeptide-20 affects skin barrier. Tewameter was used. In this instrument the water evaporation gradient, developed from the skin surface is measured by a probe that is placed perpendicularly on the skin site to be measured. The probe consists of an open cylinder containing two hygrosensors coupled with two thermistors placed at different distances from the skin surface. At both points, the relative humidity and temperature are measured and the corresponding vapour pressured is calculated. The difference between the vapour pressures at both points along the gradient is directly related to the rate of the evaporative water loss through the particular skin site.

Statistical Analysis

The improvement regarding Sew, Sesc and cR 3 were calculated according to the equation [(ScoreDn – ScoreD0)/ Score D0] × 100, where n: 20, 40 and 60.

The Wilcoxon signed rank tests were applied to study variations between measurements obtained the first and last day of the study and paired t tests between measurements of the active and vehicle side at D20, D40 and D60.

All the analyses were two-tailed. A p value < 0.05 was considered statistically significant, whereas p value < 0.1 was considered suggestive and p < 0.5 side preferred.

The data was analyzed using the Statmost statistical package.

Safety Evaluation

In order to evaluate the tolerability and the potential irritant power of the cream containing oligopeptide-20, 13 subjects both females and males, with an age between 18 - 70 years have been selected for the test, following the under mentioned inclusion criteria: 1) good state of general health; 2) no dermatopathies; 3) no pharmacological treatment in progress; 4) promise not to change usual daily routine; 5) no atopy. The test involves single application, 48 h semi-occluded patch test. The equipment used for the semi-occluded patch is composed of a small cavity of 0.64 cm 2 with a filter tissue at the bottom which is made to receive the product to test. All this is fixed to a hypoallergenic non woven adhesive tape. Treatment sites (back of the volunteers) are assessed before the first application of 0.02 ml test material (baseline) and after treatment at 30 minutes after patch removal. Negative controls (empty patch) are used to facilitate evaluation. The quantification of the skin irritation is given through a numeric scale. The average irritant score of the product is calculated from the average of the quotations obtained for each volunteer, allowing ranking from “non irritant to very irritant”. The reactions were evaluated according the following arbitrary scale [27,28].

Erythema No erythema: 0, Light erythema (hardly visible): 1, Clearly visible erythema: 2, Moderate erythema: 3, Serious erythema (dark red with possible formation of light eschars): 4.Edema No edema: 0, Very light edema (hardly visible): 1, Light edema: 2, Moderate edema (about 1 mm raised skin): 3, Strong edema (extended swelling even beyond the application area): 4.The index of average irritation was classified according amended Draize system: Non irritating: 0.5, 0.5 - 2.0: slightly irritating, 2.0 - 5.0: moderately irritating, 5.0 - 8.0 (highly irritating).

Results and Discussion

Of those recruited in the ant-aging evaluation, 20 of 22 subjects completed the 2 month treatment period. The results of 20 subjects were analyzed. None abandoned the study for adverse events or serious side effects. The most common side effect reported was dryness (Table 1). Dryness remained during the 2 month treatment and has to be mainly attributed to the poor synthesis of both creams in emollient ingredients, since the above symptoms were recorded at almost equal ratios for both the active and vehicle cream. No irritant or allergic reactions were documented during the test period.

We used direct non-invasive Visioscan VC98 technique [16] in order to evaluate skin surface. Regarding our study, Sew parameter indicative of number and width of horizontal and vertical wrinkles showed a decrease of 11.7% (p < 0.05) in the case of active side. The decrease for the vehicle side was remarkably lower (5.5%, p < 0.05) (Figure 1). Sesc parameter, indicative of dryness of stratum corneum seemed to be affected almost equally by the oligopeptide and the vehicle cream in a rather statistically suggestive manner (p < 0.1) (Figure 2).

We used optical profilometry (negative skin replicas) in order to evaluate skin microtopography, as well [17- 22]. To date most of the non-invasive methods of quantification of cutaneous relief have consisted of the replicas. The relief profile is measured by optical techique. The metal industry has for several years defined and standardized the parameters used for characterization of the surface area of the metals. These parameters are the ones used for profilometric analysis of cutaneous microrelief.

The major parameters cited in the literature for skin surface are R1, R2 and R3 [19]. The measuring of these parameters is of importance for the discussion of the actual efficacy of the products on wrinkles and skin roughness, although clinical diversity and skin microrelief and wrinkles c